SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN (3B3) V6-2.8L (ATQ)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTTESTING AND INSPECTIONTOE CONSTANT "S"
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)

Toe Constant "S"

2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)SECTION Toe Constant "S"

Toe constant "S"
Explanation:
If a wheel suspension is compressed or extended its toe will change depending on the amount of compression or extension. The resulting toe measurements are described as the toe curve.

Changes in the toe constant "S" are made by vertically moving the head of the tie rod while the vehicle is raised.

The wheel alignment computer determines the toe constant "S" using values measured in the initial and raised positions. The computer compares the measured values with the specifications and displays them on the screen.

Depending on the suspension, various adapters are necessary for raising the vehicle.


Note:
- An improperly adjusted toe constant leads to disturbances in driving behavior.
- It will be noticeable when braking, accelerating or driving over undulating road.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.