Air Bag Control Module: Service and Repair

2003 Volkswagen Passat Sedan (3B3) L4-1.8L Turbo (AWM)SECTION Service and Repair


Airbag Control Module - J234 -, Removing And Installing

CAUTION: Observe safety precautions for working on airbags

Removing
- Remove center console and cover for center instrument panel.
- Disconnect vehicle battery.







- Swing bracket - 2 - in opposite direction of arrow and pull out harness connector - 3 - from control module - 1.
- Remove nuts - 4 - and pull control module from studs (nut - 4 - = 6 Nm).


Installing
- Installation is the reverse order of removal.
- Switch ignition on.

CAUTION: Make sure no one is in the vehicle.

- Connect vehicle battery.
- If control module was replaced, it must be coded, adapt (code) components.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.