Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN (3B3) L4-1.8L TURBO (AWM)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRFRONT CAMBER
2003 Volkswagen Passat Sedan (3B3) L4-1.8L Turbo (AWM)
Front Camber
2003 Volkswagen Passat Sedan (3B3) L4-1.8L Turbo (AWM)SECTION Front Camber
Front axle camber, centering
Special tools, workshop equipment, testers, measuring instruments and auxiliary items required
- VAG 1941 Camber adjustment device
Only by moving the subframe it is possible to change the camber slightly.
- Remove noise insulation tray.
- Unscrew hex bolts -3- and -4-.
- Insert camber adjustment device --VAG 1941-.
Tightening torque of hex bolts -1- 10 Nm.
- Loosen hex bolts -1-, -2-, -5-, -6-, -7- and -8-.
- Turn bolt -2- until the specifications are achieved.
Specifications for vehicle alignment, Refer to alignment specifications.
- Relieve tension on bolt -2- and check the readings obtained, if necessary correct camber again.
- Screw in new hex bolts -7- and -8-.
- Remove camber adjustment device --VAG 1941-.
- Screw in new front hex bolts -5- and -6- and tighten, Refer to Front Suspension, Service and Repair, Front Suspension, Servicing, See item 28.
- Tighten new hex bolts -1-, -2-, -3- and -4- , Refer to Front Suspension, Service and Repair, Front Suspension, Servicing, See - item 27.
Important: The toe must be checked after each camber adjustment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.