Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003NEW BEETLE (1C1) L4-2.0L (BDC)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONRELAY BOXSERVICE AND REPAIRRELAY PANEL AND 13-POSITION RELAY PANEL
2003 Volkswagen New Beetle (1C1) L4-2.0L (BDC)
Relay Panel and 13-Position Relay Panel
2003 Volkswagen New Beetle (1C1) L4-2.0L (BDC)SECTION Relay Panel and 13-Position Relay Panel
Relay panel and 13-position relay panel, removing and installing
CAUTION!
Before working on the electrical system:
- Determine the correct coding for the antitheft radio.
- Switch ignition off
- Disconnect the battery Ground (GND) strap.
- After reconnecting battery, re-code and check operation of the anti-theft radio.
Removing
- Remove lower instrument panel trim on driver's side.
- Remove both securing screws -C- (2 Nm) and loosen all bolted connections -D- as necessary.
- Remove relay panel -B- and relay panel -A- downward.
Installing
- Install in reverse order.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.