Windshield Wiper System, Assembly

2003 Volkswagen New Beetle (1C1) L4-2.0L (AVH)SECTION Windshield Wiper System, Assembly



Windshield wiper system, assembly







CAUTION!
Before working on the electrical system:
- Determine the correct coding for the anti-theft radio.
- Switch ignition off.
- Disconnect the battery Ground (GND) strap.
- After reconnecting battery, re-code and check operation of the anti-theft radio.



1 - Wiper blade
- Adjusting rest position
2 - Wiper rubber
3 - Connecting lever
4 - Connecting rod
5 - Crank
6 - Wiper motor
7 - Hex nut M8
- 20 Nm (15 ft lb)
8 - Wiper frame
9 - Securing bolts M6
- 5 Nm (44 in.lb)
10 - Protective sleeve
11 - Cover cap
12 - Hex nut M8
- 20 Nm (15ft lb)
13 - Wiper arm
14 - Retaining clip
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.