Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003NEW BEETLE (1C1) L4-1.8L TURBO (AWP)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULEAPPLICATION AND IDCONTROL MODULE IDENTIFICATION
2003 Volkswagen New Beetle (1C1) L4-1.8L Turbo (AWP)
Control Module Identification
2003 Volkswagen New Beetle (1C1) L4-1.8L Turbo (AWP)SECTION Control Module Identification
On Board Diagnostic (OBD), Technical Data
Control module identification
The control module version is displayed when the scan tools VAG1551 or VAG1552 or the tester VAS5051 is connected and Motronic Engine Control Module (ECM) -J220- selected.
Equipment
Engine code AWP/AWV
System designation Motronic ME7.5
Exhaust emission limits according to LEV3)
EPC System Yes
On Board Diagnostic (OBD) OBD II
Output Diagnostic Test Mode (DTM) Yes
Mode of data transmission to VAG1551/1552 Rapid data transfer
DTC memory Permanent memory 1)
Memory for learned values Volatile memory 2)
Oxygen sensor control 2 oxygen sensors
Knock sensor 2 knock sensors
Intake manifold switchover valve No
Camshaft adjustment Yes
Charge pressure regulation Yes
Secondary air system Yes
1) Independent of voltage supply.
2) Values are erased when voltage supply is interrupted.
3) LEV = Low Emission Vehicles (max. emission values 0.075 g/mi HC).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.