Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003JETTA SEDAN (9M2) V6-2.8L (BDF)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESWITH GENERIC SCAN TOOLDIAGNOSTIC MODE 2: CHECK OPERATING CONDITIONS
2003 Volkswagen Jetta Sedan (9M2) V6-2.8L (BDF)
Diagnostic Mode 2: Check Operating Conditions
2003 Volkswagen Jetta Sedan (9M2) V6-2.8L (BDF)SECTION Diagnostic Mode 2: Check Operating Conditions
Diagnostic mode 2: Checking operating conditions
Function
This diagnostic mode displays the operating conditions at which an emission relevant malfunction was detected and stored by the Engine Control Module (ECM).
Procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Depending on the desired operating condition:switch on ignition
or
Start engine and let run at idle.
- Under address word 33, select "Diagnostic mode 2: Check operating conditions."
- Select the desired operating condition "PID XX".
NOTE: The operating conditions are sorted by the PID (parameter-identifications).
PID Display operating conditions
03: Condition of the fuel system
04: Calculated load condition value
05: Cooling fluid temperature
06: Short time gasoline-air ratio bank 1
07: Gasoline-air ratio bank 1
12: Engine rotations per minute (RPM)
13: Vehicle speed
- End diagnosis and switch ignition off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.