Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003JETTA SEDAN (9M2) V6-2.8L (BDF)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERKEYLESS ENTRY TRANSMITTER BATTERYSERVICE AND REPAIR
2003 Volkswagen Jetta Sedan (9M2) V6-2.8L (BDF)
Keyless Entry Transmitter Battery: Service and Repair
2003 Volkswagen Jetta Sedan (9M2) V6-2.8L (BDF)SECTION Service and Repair
Batteries For Key With Radio Remote Control (foldable) Removing And Installing --> 05.01
1 - Key with alternating code transponder
2 - Radio remote container - upper
3 - Light Emitting Diode (LED)
- This Light Emitting Diode (LED) must light up when remote control is operated.
- If Light Emitting Diode (LED) does not light up when remote control is operated, battery is completely discharged and must be replaced.
4 - Battery
- Remove battery
- Install battery
5 - Radio-frequency unit - lower part
Removing
- Insert screwdriver in slot between radio-frequency unit - 1 - and key - 2 -.
- Rotate screwdriver in direction of - arrow - and detach radio frequency unit from key.
- Press apart radio-frequency unit - 1 - using key bit of key - 2 -.
- Use a screwdriver to unclip battery - 1 - out of holders - 2 - in direction of - arrow -.
Installing
Note polarity and installation position of battery when installing.
- Place battery - 1 - in radio-frequency unit - 2 - with positive terminal downward (positive terminal is marked in housing).
- Press on battery with light pressure to engage it in radio-frequency unit.
- Reattach cover to radio-frequency unit (do not damage seal).
- Then engage radio-frequency unit on key.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.