Code Control Module

ABS control module, coding

Note:
- All functions which could previously be performed with V.A.G. 1551 can now also be carried out with the tester VAS 5051.
- ABS warning light -K47- and warning light for brake system -K118- flash when ABS control module (w/EDL) -J104- is coded with 00000. An entry is not made in the DTC memory.
- The ABS control module (w/EDL) -J104- must be recoded if the vehicle relevant coding is not displayed or the control module has been replaced.
Coding is only possible after the Workshop Code (WSC) has been introduced into V.A.G. 1551.

Test sequence
- Connect V.A.G 1551 scan tool and select (address word 03) brake electronics control module with ignition switched on.
- Establish engine code.





Indicated on display:
- Input 07 for the function "Code control module" and confirm with Q key.





Indicated on display:
- Confirm input with Q key.





Indicated on display:
- Enter the relevant code number for this vehicle and confirm with Q key.
Coding variations.





On the display the control module identification and coding are displayed e.g.:

Vehicle data label

Explanation of the PR. numbers on vehicle data label
Various wheels are installed depending on engine and equipment level. These are identified by the PR. numbers.
The wheel installed in the vehicle is documented on the vehicle data label with the relevant PR number.











Location of optional equipment number (PR No.) on vehicle data plate (arrow)
Depending on equipment level, the PR number is printed in different locations on the vehicle data label.
In this example the vehicle is equipped with the standard wheel 1ZM -arrow-.
The PR numbers are critical for the assignment of coding.

Table for ABS, coding

Note: The control unit must be coded with the same code number as the previous control unit installed in the vehicle





With control unit identification number 1C0 907 379 C/J/L for vehicles from 10.00

Table for ABS/EDL/ASR, coding

Note: The control module must be coded with the same code number as the previous control module installed in the vehicle





With control unit identification number 1C0 907 379 D/K for vehicles from 10.00

Table for ABS/EDL/ASR/ESP, coding

Vehicles with front wheel drive

Note: The control module must be coded with the same code number as the previous control module installed in the vehicle

With control unit identification number 1C0 907 379 E/G/M for vehicles from 10.00





1) Overview of types of brakes (PR No ).
2) Overview of types of vehicle.

Table for ABS/EDL/ASR/ESP, coding

Note: The control module must be coded with the same code number as the previous control module installed in the vehicle

4MOTION vehicles





With control unit identification number 1C0 907 379 F/H/N

1) Overview of types of brakes (PR No ).
1) Overview of types of vehicle.