Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003GOLF (1J1) L4-1.9L DSL TURBO (ALH)REPAIR AND DIAGNOSISDIAGRAMSCONNECTOR VIEWSSTEERING COLUMN
2003 Volkswagen Golf (1J1) L4-1.9L DSL Turbo (ALH)
Steering Column
2003 Volkswagen Golf (1J1) L4-1.9L DSL Turbo (ALH)SECTION Steering Column
Steering Column Switches, Connector Assignments
Windshield wiper/washer and multi-function indicator (MFI) switches
A - Connector, 4 pin
1 - MFI call-up button - right
2 - MFI call-up button - left
3 - MFI call-up button - terminal 31(Ground)
4 - MFI safe switch - Reset
5 - Windshield wiper intermittent regulator - to intermittent wash/wipe relay
6 - Windshield wiper intermittent regulator - terminal 31 (Ground)
B - Connector, 8 pin
1 - Windshield wiper switch - terminal 53
2 - Windshield wiper switch - terminal 31
3 - Windshield wiper switch - terminal 53e
4 - Windshield wiper switch - terminal 53c
5 - Windshield wiper switch - rear window wiper
6 - Windshield wiper switch - terminal 53b
7 - Windshield wiper switch - intermittent operation
8 - Windshield wiper switch - terminal 53a
Turn signal, headlight, flasher and parking light switch
C - Connector, 12 pin
1 - Switch for headlights/flasher - terminal 30
2 - Switch for headlights/flasher - terminal 30
3 - Turn signal switch - terminal L
4 - Parking light switch - terminal P
5 - Turn signal switch - terminal 49a
6 - Horn contact - terminal 71
7 - Switch for headlights/flasher - terminal 56
8 - Switch for headlights/flasher - terminal 56b
9 - Parking light switch - terminal PL
10 - Parking light switch - terminal PR
11 - Turn signal switch - terminal R
12 - Switch for headlights/flasher - terminal 56a
Cruise control switch
D - Connector, 10 pin
1 - Open
2 - Switch for CCS - On / Off
3 - Switch for CCS - Set / delay
4 - Switch for CCS - Reset / Resume saved speed / Accelerate
5 - Switch for CCS - Reset / Resume saved speed / Accelerate
6 - Switch for CCS - On / Off
7 - Switch for CCS
8 - 10: Open
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.