Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003GTI (1J1) L4-1.8L TURBO (AWP)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESWITH GENERIC SCAN TOOLDIAGNOSTIC MODE 7: CHECK TEST RESULTS OF COMPONENTS THAT ARE CONTINUOUSLY MONITORED
2003 Volkswagen GTI (1J1) L4-1.8L Turbo (AWP)
Diagnostic Mode 7: Check Test Results of Components That Are Continuously Monitored
2003 Volkswagen GTI (1J1) L4-1.8L Turbo (AWP)SECTION Diagnostic Mode 7: Check Test Results of Components That Are Continuously Monitored
Diagnostic mode 7: Check test results of components that are continuously monitored
Function
This diagnostic mode indicates all stored DTCs of components and systems which are continuously monitored.
Requirement
- There must not be any DTCs stored in DTC memory, Diagnostic mode 3: Check DTC memory. Diagnostic Mode 3: Check DTC Memory
Work procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Start engine and let run at idle.
NOTE:
Only if engine does not start:
- Operate starter for approx. 6 seconds. Do not switch ignition off afterward.
- Under address word 33, select "Diagnostic mode 7: Check test results of components that are continuously monitored".
The number of stored malfunctions or "0 malfunctions detected" is displayed.
- End diagnosis and switch ignition off.
- Repair stored malfunctions according to DTC table:
- SAE P0xxx-DTCs. P0010
- SAE P1xxx-DTCs. P1102
- SAE P2xxx-DTCs. P2101
- SAE P3xxx-DTCs. P3081
NOTE:
- The DTC table is sorted by SAE codes.
- "EPC"-relevant malfunctions are also indicated by the warning lamp for Electronic Power Control ("EPC warning lamp") in the instrument cluster.
- Erase DTC memory after repairing malfunction, Diagnostic mode 4: Reset/erase diagnostic Data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.