Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003EUROVAN V6-2.8L (AXK)REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSMISSION CONTROL SYSTEMSRELAYS AND MODULES - TRANSMISSION AND DRIVETRAINRELAYS AND MODULES - A/TCONTROL MODULESERVICE AND REPAIRAUTOMATIC TRANSMISSION CONTROL MODULE (TCM) -J217
2003 Volkswagen Eurovan V6-2.8L (AXK)
Automatic Transmission Control Module (TCM) -J217
2003 Volkswagen Eurovan V6-2.8L (AXK)SECTION Automatic Transmission Control Module (TCM) -J217
automatic transmission control module (TCM) -J217
Fig. 4 Location of automatic transmission control module (TCM) -J217-
The control module is located in the left footwell, on the "A" pillar.
If the engine or transmission control module is replaced, the system must be reset.
Fig. 5 Removing and installing automatic transmission control module (TCM) -217
^ Remove relay plate cover and unhook relay plate.
^ Switch ignition off, release multi-pin connector in direction of arrow and pull out of control module.
^ Remove control module.
Installation is performed in the reverse order.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.