Compressor and Bracket, Assembly

2003 Volkswagen Eurovan V6-2.8L (AXK)SECTION Compressor and Bracket, Assembly



Compressor And Bracket, Assembly

Compressor bracket, removing and installing

Required:

- Torque wrench 5 - 50 Nm (44 in lb - 40 ft lb)


NOTE:
Compressor bracket and related parts can be removed and installed without discharging A/C refrigerant system.







1 - Generator (GEN) compressor and power steering pump bracket
- Removing:
- Remove Generator (GEN)
- Remove compressor
- Remove power steering Pump
- Installing:
- First install guide bolts -3-
2 - Washer
- 8.4 x 16 x 1.6
3 - Guide bolt (2x)
- M8 x 60
- 25 Nm (18 ft lb)
4 - Socket head bolt

- M8 x 60
- 25 Nm (18 ft lb)
5 - Refrigerant hoses
6 - Compressor

- Removing:
- Loosen bolts -8-, knock-back clamping sleeves on compressor, then remove bolts completely.
7 - Ribbed drive belt
8 - Hex bolt
- M10 x 112
- 45 Nm (33 ft lb)
9 - Socket head combination bolt

- M8 x 25
- 25 Nm (18 ft lb)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.