Radio Frequency Remote Control, Synchronizing

Radio Frequency Remote Control, Synchronizing (Vehicles From 10.00)

For vehicles up to 10.00

It is necessary to synchronize the radio frequency remote control key if:
- New additional keys (maximum 4 keys) are obtained for the vehicle and/or defective keys are replaced.
- Central Locking System Control Module (remote control) - J276 - is replaced.

or:

- Complete locking system was replaced.

Adaptation of new keys to anti-theft immobilizer is always performed first.

Successful synchronizing of a key erases previous synchronizing (code) of other keys.

Therefore, entire set of keys (maximum 4 keys) have to be re-synchronized, immediately, one after another.

NOTE: During synchronizing, no other vehicle with radio frequency remote control may be within an area of 20 m (50 ft.). If this condition is not observed, it is possible synchronizing will be influenced by an outside vehicle.

- Switch ignition on for maximum 3 seconds with master key only.
- Switch ignition off and pull out key.

Synchronizing of key must now take place within 20 seconds.







- While holding lock button - 2 -, press unlock button - 1 - three times.
- Release lock button - 2 -. Indicator light - 3 - in key blinks five times.

If control module has accepted synchronizing of the key, the vehicle locks and unlocks once and emergency flasher system is activated accordingly.

Any additional keys must be synchronized within next 20 seconds after new key is completed To synchronize additional keys, (maximum 3 more) hold lock button - 2 - and press button - 1 - 3 times.

If control module has accepted synchronizing of the key, vehicle locks and unlocks once and emergency flasher system is activated accordingly.

Synchronizing process ends if 20 second time limit has been exceeded or ignition was switched off for at least 5 seconds. If all 4 keys were synchronized, the synchronizing process automatically ends.