From 10.00

2000 Volkswagen New Beetle (1C1) L4-1.8L Turbo (APH)SECTION From 10.00



Data Bus On Board Diagnostic Interface -J533- From 10.00, coding (function 07)

- Connect VAG 1551 Scan tool (ST), input address word 19 "Gateway" and then press button until "Select function XX" is shown in display.
- Press buttons -0- and -7- to select function "Code control module".

Indicate on display:


Rapid data transfer Q
01 - Code control unit



- Press -Q- button to confirm input.

Coding

Indicate on display:


Code control module
Enter code number XXXXX (0 - 32000)



- Enter code number compiled from code table.

Control modules to power-train databus Code:
ABS activated 00002
Airbag activated 00004
ABS and Airbag activated 00006


NOTE: Transmission control module message is not codified because it is automatically learned.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.