Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2000JETTA SEDAN (9M2) V6-2.8L (AFP)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSTHREE WAY CATALYTIC CONVERTER (TWC), CHECKINGWITH GENERIC SCAN TOOL
2000 Volkswagen Jetta Sedan (9M2) V6-2.8L (AFP)
With Generic Scan Tool
2000 Volkswagen Jetta Sedan (9M2) V6-2.8L (AFP)SECTION With Generic Scan Tool
Three Way Catalytic Converter (TWC), Checking
Function test
- Select the measuring value "Test-ID 01: Catalytic converter" and check whether the specified values are being reached, Diagnostic mode 6: Check test results of components that are not continuously monitored.
Diagnostic Mode 6: Check Test of Parts Not Constantly Monitored
- End diagnosis and switch ignition off.
If the specified values are exceeded:
- Replace the front exhaust pipe with catalytic converter:
- Vehicles with engine code AFP, item 10,
- Vehicles with engine code BDF, item 14.
Continuation for all vehicles
- Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
Clearing Diagnostic Trouble Codes
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.