Instrument Cluster, Coding (Function 07)

Instrument Cluster, Coding (function 07)

Using this function the instrument cluster can be coded as follows:
- Available equipment activation
- Market versions
- Service Intervals
- Distance impulse number (K-number)


NOTE: The code table lists only those combinations applicable to Golf/Jetta through m.y. 2002.


Initiating coding
- Connect scan tool VAG 1551, select operating mode 1 "Rapid data transfer", switch on ignition and enter address word 17 "instrument cluster".
- Press -Q- button to confirm input.
- Press -> button until "Select function" is displayed..

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -7- to select "Code control module" function 07.

Indicated on display:


Rapid data transfer Q
07 - Code control module


- Press -Q- button to confirm input.

Indicated on display:


Code Control Module
Enter code number XXXXX (0-32000)


- Determine vehicle particulars and input code number using coding table.

Example:


NOTE: Values shown below are examples only!!


07 Available equipment
2 Market version
3 Service Interval
2 Distance impulse number

Indicated on display (example only):


Code Control Module Q
Enter code number 07232 (0-32000)


- Press -Q- button to confirm input.

Indicated on display (example only):


1J0920906N KOMBI+WEGFSP VDO X07 ->
Coding 07232 WSC 00000


- Press -> button.

Indicated on display:


Rapid data transfer HELP
Select function XX


End function:
- Press buttons -0- and -6- to select "End Output" function 06.

Indicated on display:


Rapid data transfer Q
06 - End Output


- Press -Q- button to confirm input.

Indicated on display


Rapid data transfer Help
Enter address word XX


The tester is now in basic function again.

Code table:







Distance impulse number, determining