Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2000JETTA SEDAN (9M2) V6-2.8L (AFP)REPAIR AND DIAGNOSISBODY AND FRAMEBODY CONTROL SYSTEMSTESTING AND INSPECTIONCENTRAL LOCKING SYSTEM (VEHICLES WITHOUT POWER WINDOWS)ERASING DTC MEMORY (FUNCTION 05)
2000 Volkswagen Jetta Sedan (9M2) V6-2.8L (AFP)
Erasing DTC Memory (Function 05)
2000 Volkswagen Jetta Sedan (9M2) V6-2.8L (AFP)SECTION Erasing DTC Memory (Function 05)
NOTE: The VAG 1552 Mobile Scan Tool (ST) can be used instead of the VAG 1551 Scan Tool (ST), however a print-out is not possible.
- Connect VAG 1551 scan tool. VAG 1551 Scan Tool Connecting
- Initiate On Board Diagnostic (OBD). Initiating On Board Diagnostic Program
Requirements
- Functional check completed
- All malfunctions repaired
- DTC memory checked again
Indicated on display
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -5- to select "Erase DTC Memory" function 05.
Indicated on display
Rapid data transfer Q
05 - Erase DTC Memory
- Press -Q- button to confirm input.
Indicated on display
Rapid data transfer ->
DTC Memory is erased!
- Press -> button.
Indicated on display
Rapid data transfer HELP
Select function XX
NOTE:
- This message indicates an error in the test sequence.
Attention! ->
DTC Memory was not interrogated
- Adhere exactly to the test sequence: first check DTC memory and then erase DTC memory
- Press buttons -0- and 6- to select "End Output" function 06.
Indicated on display
Rapid data transfer Q
06 - End Output
- Press -Q- button to confirm input.
Indicated on display
Rapid data transfer HELP
Insert address word XX
- Switch ignition off.
- Disconnect scan tool from Data Link Connector (DLC).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.