Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2000GTI (1J1) L4-1.8L TURBO (AWD)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESDIAGNOSTIC MODE, SELECTINGDIAGNOSTIC MODE 1: CHECK MEASURED VALUES
2000 Volkswagen GTI (1J1) L4-1.8L Turbo (AWD)
Diagnostic Mode 1: Check Measured Values
2000 Volkswagen GTI (1J1) L4-1.8L Turbo (AWD)SECTION Diagnostic Mode 1: Check Measured Values
Diagnostic Mode 01: Obtain data
Diagnostic Mode 01 is used to display and monitor all emissions related measured values.
Depending on scan tool and protocol used, the information displayed in diagnostic mode 01 may be referred to by different names such as Test-ID (TID), Hex-ID, Component-ID (CID), On-Board Diagnostic Monitor Identifier (OBDMID), or contain no name at all and be referenced by only a number.
Test requirement
- Coolant temperature at least 80�C.
Procedure
- Connect the scan tool.
- Start the engine and run at idle.
- Select "Diagnostic Mode 1: Obtain data."
- From the following table, select the desired the "PID" that is to be monitored, e.g. "PID 05-Coolant temperature".
The current values of the component or system that is being monitored will be displayed on the scan tool screen.
- Switch the ignition off.
- End of diagnosis.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.