Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999PASSAT SYNCRO SEDAN (3B2) V6-2.8L (AHA)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSAXLE NUTFRONT
1999 Volkswagen Passat Syncro Sedan (3B2) V6-2.8L (AHA)
Front
1999 Volkswagen Passat Syncro Sedan (3B2) V6-2.8L (AHA)SECTION Front
Drive shaft to wheel hub
Hex bolt
Bolt M14: 115 Nm plus additional 180° 1/2 turn
Bolt M16: 190 Nm plus additional 180° 1/2 turn
Notes:
- Replace each time after removing.
- When tightening, the vehicle must be on the ground.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.