Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999PASSAT SEDAN (3B2) V6-2.8L (AHA)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORSERVICE AND REPAIR
1999 Volkswagen Passat Sedan (3B2) V6-2.8L (AHA)
Vehicle Speed Sensor: Service and Repair
1999 Volkswagen Passat Sedan (3B2) V6-2.8L (AHA)SECTION Service and Repair
Vehicle speed sensor (VSS) -G68-:
- Location: The vehicle speed sensor is located on top of the transmission.
Removing and installing vehicle speed sensor:
- Pull black connector off sensor.
- Remove bolt and pull sensor out.
- Replace seal.
Installation is performed in reverse order of removal.
- Tighten bolt to 10 Nm (7 ft lb).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.