Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999JETTA SEDAN (9M2) V6-2.8L (AFP)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRREAR WHEELTOE, ADJUSTING
1999 Volkswagen Jetta Sedan (9M2) V6-2.8L (AFP)
Toe, Adjusting
1999 Volkswagen Jetta Sedan (9M2) V6-2.8L (AFP)SECTION Toe, Adjusting
Rear wheel toe, adjusting
If vehicle is out of specification, check trim height and balance if necessary
Rear axle total toe is not adjustable
Only by sliding brackets is it possible to balance individual toe values.
If, after attempting above method, vehicle remains out of specification, check axle beam for damage and replace if necessary
- Loosen all bolts at bracket -1-
- Slide bracket -1- laterally.
2. Rear axle beam
- Tighten bolts 75 Nm (55 ft. lbs.).
NOTE: Always use new bolts
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.