Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999GTI (1W1) V6-2.8L (AAA)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTRANSMISSION POSITION SENSOR/SWITCHSERVICE AND REPAIR4 SPEED AUTOMATIC 01M REMOVE & INSTALL MULTI-FUNCTION TR SWITCH
1999 Volkswagen GTI (1W1) V6-2.8L (AAA)
4 Speed Automatic 01M Remove & Install Multi-Function TR Switch
1999 Volkswagen GTI (1W1) V6-2.8L (AAA)SECTION 4 Speed Automatic 01M Remove & Install Multi-Function TR Switch
Multi-Function Transmission Range (TR) Switch -F125-
Removing and installing -F125-
- Switch ignition off
- Disconnect connector from multi-function TR switch.
- Remove bolt and retainer.
- Remove multi-function TR switch.
- Replace seal.
Installation is performed in the reverse order.
- Tighten bolt to 10 Nm (7 ft lb).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.