With Generic Scan Tool

1999 Volkswagen GTI (1J1) L4-2.0L (AEG)SECTION With Generic Scan Tool


Three Way Catalytic Converter (TWC), Checking

Function test
- Select the measuring value "Test-ID 01:
Catalytic converter" and check whether the specified values are being reached, Diagnostic mode 6: Check test results of components that are not continuously monitored. Diagnostic Mode 6: Check Test Of Parts Not Constantly Monitored
- End diagnosis and switch ignition off.

If the specified values are exceeded:
- Replace the front exhaust pipe with catalytic converter:

Continuation for all vehicles
- Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.