Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999CABRIO (1V7) L4-2.0L (ABA)REPAIR AND DIAGNOSISSTARTING AND CHARGINGPOWER AND GROUND DISTRIBUTIONFUSE BLOCKSERVICE AND REPAIRMULTI-POINT CONNECTORS ON FUSE/RELAY PANEL, REMOVE/INSTALL
1999 Volkswagen Cabrio (1V7) L4-2.0L (ABA)
Multi-point Connectors on Fuse/Relay panel, Remove/install
1999 Volkswagen Cabrio (1V7) L4-2.0L (ABA)SECTION Multi-point Connectors on Fuse/Relay panel, Remove/install
Multi-point connectors on fuse/relay panel, removing and installing
Removing
- Pull open locking slide -1 - on back of fuse/relay panel in direction indicated (arrow).
- Depress locking clip (arrow) and pull multi-point connector from fuse/relay panel.
Installing
- Insert connectors so that locking pins -2- fac locking slide -1-.
- Push multi-point connector into appropriate location -4- until locking clip -3- engages.
- When all connectors are installed, push lock slide -1- in direction indicated (arrow) until locked.
Note: Fully insert all multi-point connectors into fuse/ panel before engaging locking slide -1-.
Removing
- Pull open locking slide -1 - on back of fuse/relay panel in direction indicated (arrow).
- Depress locking clip (arrow) and pull multi-point connector from fuse/relay panel.
Installing
- Insert connectors so that locking pins -2- fac locking slide -1-.
- Push multi-point connector into appropriate location -4- until locking clip -3- engages.
- When all connectors are installed, push lock slide -1- in direction indicated (arrow) until locked.
Note: Fully insert all multi-point connectors into fuse/ panel before engaging locking slide -1-.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.