Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999CABRIO (1V7) L4-2.0L (ABA)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRADJUSTING
1999 Volkswagen Cabrio (1V7) L4-2.0L (ABA)
Adjusting
1999 Volkswagen Cabrio (1V7) L4-2.0L (ABA)SECTION Adjusting
FRONT WHEEL CAMBER, ADJUSTING
NOTE: For this procedure, use the tools shown in the following illustration or their equivalents.
- Install tool and tension slightly.
- Loosen bolts connecting suspension strut to wheel bearing housing.
- Set camber to specification by turning tool spindle.
- Tighten suspension strut/wheel bearing housing bolts.
- Check camber adjustment and repeat procedure if necessary.
TOE
- Adjust total toe on right tie rod only, set left left tie rod to length.
NOTE: For this procedure, use the tools shown in the following illustration or their equivalents.
- Install tool and tension slightly.
- Loosen bolts connecting suspension strut to wheel bearing housing.
- Set camber to specification by turning tool spindle.
- Tighten suspension strut/wheel bearing housing bolts.
- Check camber adjustment and repeat procedure if necessary.
TOE
- Adjust total toe on right tie rod only, set left left tie rod to length.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.