Electro/Hydraulic Assembly Overview

1999 Volkswagen Cabrio (1V7) L4-2.0L (ABA)SECTION Electro/Hydraulic Assembly Overview
Electro/hydraulic convertible top, assembly overview






1 - Convertible top switch
- In center console

2 - Control module
- Under rear seat

3 - Convertible top frame main bracket
- Qty. 2

4 - Hydraulic cylinder
- Qty. 2

5 - Fluid level indicator
- Hydraulic oil level must be between min. and max. marks when convertible top is open.
- Oil for convertible top hydraulics G 002 000 in 1000 ml. (34f1 oz.) container.

6 - Oil filler plug
- 5 Nm (44 in.lb)

7 - Pressure relief screw
- Removing pressure relief screw releases pressure in hydraulic system allowing manual convertible top operation.

8 - Hydraulic hose

9 - Hydraulic pump
- For vehicles up to VIN 1E-T-018000 there are slight design changes.

10 - Reed contact switch
- Qty. 2
- Contact switches on top of rear side trim together with rod magnets on convertible top cover prevent convertible top from closing when top cover is installed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.