Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999CABRIO (1V7) L4-2.0L (ABA)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESERASE DTC MEMORY
1999 Volkswagen Cabrio (1V7) L4-2.0L (ABA)
Erase DTC Memory
1999 Volkswagen Cabrio (1V7) L4-2.0L (ABA)SECTION Erase DTC Memory
Erase DTC Memory
Requirements
- Malfunction was repaired
- DTC memory was checked again
- Function test was performed
- Fault read out device V.A.G 1551, connecting.
- Initiate On Board Diagnostic (OBD). On Board Diagnostic (OBD) For Radio-Frequency Remote Control For Central Locking, Initiating
- Switch printer on via Print -button (indicator lamp in button illuminates).
Indicated on display:
Rapid data transfer HELP
Select function XX
- Press buttons - 0 - and - 5 - to select "Erase DTC Memory", function 05.
Indicated on display:
Rapid data transfer Q
05 - Erase DTC Memory
- Press Q button to confirm input.
Indicated on display:
Rapid data transfer ->
DTC Memory is erased.
- Press --> -button.
Indicated on display:
Rapid data transfer HELP
Select function XX
NOTE:
- Test sequence is faulty if this message is displayed.
WARNING: DTC memory was not checked
- Follow test sequence exactly: first check DTC memory, then erase it.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.