Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1996JETTA (1H2) L4-2.0L (ABA)REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLECONTROL MODULESERVICE AND REPAIR096 TRANSMISSION
1996 Volkswagen Jetta (1H2) L4-2.0L (ABA)
096 Transmission
1996 Volkswagen Jetta (1H2) L4-2.0L (ABA)SECTION 096 Transmission
TRANSMISSION CONTROL MODULE -J217- (68 PIN)
Removal
- Release multi-pin connector lock, then disconnect multi-pin connector.
- Remove TCM.
Installation
- Place multi-pin connector in position on control module locating pins (-arrows-), then lock multi-pin connector.
Removal
- Release multi-pin connector lock, then disconnect multi-pin connector.
- Remove TCM.
Installation
- Place multi-pin connector in position on control module locating pins (-arrows-), then lock multi-pin connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.