SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1996JETTA (1H2) L4-2.0L (ABA)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSALARM MODULESERVICE AND REPAIR
1996 Volkswagen Jetta (1H2) L4-2.0L (ABA)

Alarm Module: Service and Repair

1996 Volkswagen Jetta (1H2) L4-2.0L (ABA)SECTION Service and Repair


Alarm system control module -J284-, removing and installing

Removing





- Remove driver's side instrument panel trim.

- Disconnect 6-pin and 10-pin connectors from alarm system control module -J284-, located behind bracket on left A-pillar.

Vehicles withcruise control:

- Disconnect 12-pin connector from cruise control, control module -J213-, located behind bracket on left A- pillar.

Note: The alarm system control module - J284- and cruise control control module -J213- are located on the same mounting plate.

- Remove nut -1 - from assembly carrier.

- Pull mounting plate locking lugs out from bracket and remove mounting plate with control module -2-.

- Remove control module mounting bolts from mounting plate and remove control module.


Install in reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.