Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1996GTI (1H1) V6-2.8L (AAA)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSRELAYS AND MODULES - TRANSMISSION AND DRIVETRAINRELAYS AND MODULES - A/TCONTROL MODULETECHNICAL SERVICE BULLETINSECM/TCM - COMPONENT REPLACEMENT IDENTIFIERS
1996 Volkswagen GTI (1H1) V6-2.8L (AAA)
ECM/TCM - Component Replacement Identifiers
1996 Volkswagen GTI (1H1) V6-2.8L (AAA)SECTION ECM/TCM - Component Replacement Identifiers
Group: 00
Number: 97-06
Date: July 31, 1997
Subject:
Digimat Control Module (TCM), Identification
Model(s):
Golf, Jetta 50-State 1993 --> 1997
Supersedes T.B. Group 00 Number 96-03 dated Dec. 20, 1996
Use the following chart to identify which Transmission Control Modules (TCM) are available for various 50-state ECM/TCM combinations.
Note:
^ This Bulletin should be used as a reference only. DO NOT update a vehicle unless a specific condition has been identified.
^ When replacing a TCM for any reason, the TCM must be paired with the Engine Control Module (ECM) according to the charts above.
^ Vehicle Identification Numbers (VIN) are for general reference only. Most VINs shown are approximate.
^ When multiple TCM Part Numbers are listed for a particular ECM/TCM combination, these are shown in order of development i.e., the earliest TCM at the top with later TCMs following below.
CAUTION!
Part numbers are for reference only. Always check with your Parts Dept. for the latest information.
Number: 97-06
Date: July 31, 1997
Subject:
Digimat Control Module (TCM), Identification
Model(s):
Golf, Jetta 50-State 1993 --> 1997
Supersedes T.B. Group 00 Number 96-03 dated Dec. 20, 1996
Use the following chart to identify which Transmission Control Modules (TCM) are available for various 50-state ECM/TCM combinations.
Note:
^ This Bulletin should be used as a reference only. DO NOT update a vehicle unless a specific condition has been identified.
^ When replacing a TCM for any reason, the TCM must be paired with the Engine Control Module (ECM) according to the charts above.
^ Vehicle Identification Numbers (VIN) are for general reference only. Most VINs shown are approximate.
^ When multiple TCM Part Numbers are listed for a particular ECM/TCM combination, these are shown in order of development i.e., the earliest TCM at the top with later TCMs following below.
CAUTION!
Part numbers are for reference only. Always check with your Parts Dept. for the latest information.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.