Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1994GOLF (1H1) L4-1.8L (ACC) CANREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSYSTEM RELAYLOCATIONS
1994 Volkswagen Golf (1H1) L4-1.8L (ACC) Can
System Relay: Locations
1994 Volkswagen Golf (1H1) L4-1.8L (ACC) CanSECTION Locations
Relay Location On Fuse/relay Panel:
Important!
Obtain radio security code and disconnect battery ground strap before working on electrical system.
NOTE:
- Relay and fuse location may not match those shown below depending on vehicle accessories and optional equipment. See appropriate wiring diagrams.
- Number in parentheses indicates production control number stamped on relay housing.
Relay locations on fuse/relay panel
1 - A/C Relay (13)
2 - Rear Window Wiper/Washer Relay (72)
3 - ECM (Engine control Module)
3 - Power Supply Relay (30, 109, 288)
4 - Load Reduction Relay (18)
5 - Open
6 - Emergency Flasher Relay (21)
7 - Open
8 - Washer/Wiper Intermittent Relay (19, 99)
9 - Seat Belt Warning System Relay (4, 29)
10 - Fog Light Relay
11 - Dual-Horn Relay (53) Or Bridge For Horn
12 - Fuel Pump Relay (67, 80,167) Or Glow Plug Relay (102,104)
Separate relays above fuse/relay panel
13 - Heated Oxygen Sensor (HO2S) Control Module
14 - Park/Neutral Position Relay (150)
15 - Open
16 - Open
17 - Open
18 - Open
19 - Open
20 - Open
21 - Open
22 - Open
23 - Open
24 - Open
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.