Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Gear
2025 Toyota Sequoia CapstoneSECTION Steering Gear
STEERING GEAR
| Tie rod assembly ball joint turning torque | 0.98 to 3.92 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf) |
| Rack and pinion power steering gear assembly total preload (Turning) | 2.09 to 4.31 N*m (22 to 43 kgf*cm, 19 to 38 in.*lbf) |
| Standard steering rack boot clamp clearance | 6.0 mm (0.236 in.) or less |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.