Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation [09/2014 - 11/2017]: Procedure
- INSTALL RADIO RECEIVER ASSEMBLY
- INSTALL NO. 1 RADIO BRACKET
Refer to PROCEDURE - Step 2
- INSTALL NO. 2 RADIO BRACKET
Refer to PROCEDURE - Step 3
- INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET
Refer to PROCEDURE - Step 4
- INSTALL CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
- INSTALL FRONT PANEL GARNISH RH
Refer to PROCEDURE - Step 8
- INSTALL FRONT PANEL GARNISH LH
Refer to PROCEDURE - Step 9
- INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 10
- INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 11
- INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 12
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [09/2014 - 10/2015] , or refer to INITIALIZATION [10/2015 - 11/2017]
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.