Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation [09/2014 - 11/2017]: Procedure
2025 Toyota Sequoia CapstoneSECTION Procedure
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL NAVIGATION ANTENNA ASSEMBLY
- Install the navigation antenna assembly with the 2 screws.
- Engage the 3 clamps.
- INSTALL DEFROSTER NOZZLE ASSEMBLY
Refer to PROCEDURE - Step 9
- INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
Refer to PROCEDURE - Step 10
- INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT
Refer to PROCEDURE - Step 11
- INSTALL NO. 3 HEATER TO REGISTER DUCT
Refer to PROCEDURE - Step 12
- INSTALL NO. 1 HEATER TO REGISTER DUCT
Refer to PROCEDURE - Step 13
- INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
Refer to INSTALLATION [09/2014 - 11/2017]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.