Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2025SEQUOIA CAPSTONEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 68 (NAVIGATION SYSTEM - SERVICE INFORMATION)MULTI-DISPLAYINSTALLATION [10/2022 - ]PROCEDURE

2025 Toyota Sequoia Capstone

Installation [10/2022 - ]: Procedure

2025 Toyota Sequoia CapstoneSECTION Procedure

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL MULTI-DISPLAY ASSEMBLY
INSTALL NO. 1 MULTI-DISPLAY BRACKET
1. for 8 Inch Display:
  1. Install the No. 1 multi-display bracket with the 6 screws.
2. for 10.3 Inch Display:
  1. Install the No. 1 multi-display bracket with the 3 screws.

INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET

Engage the 2 clips as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install the multi-display assembly with bracket with the 2 bolts.
Engage the clamp.
Connect each connector.

INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 8 Inch Display)
Refer to PROCEDURE - Step 13
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 10.3 Inch Display)
Refer to PROCEDURE - Step 14

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.