Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal [09/2014 - 11/2017]: Procedure
2025 Toyota Sequoia CapstoneSECTION Procedure
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE NO. 1 LANE RECOGNITION COVER
Refer to PROCEDURE - Step 1
- REMOVE LANE DEPARTURE WARNING CAMERA
- Disengage the 3 guides and remove the lane departure warning camera as shown in the illustration.NOTE:
- If the lane departure warning camera bracket is deformed or damaged, replace it together with the windshield glass.
- If the lane departure warning camera is dropped, replace it with a new one.
- Disconnect the connector.NOTE:
Do not pull the harness forcibly when disconnecting the connector.
- Disengage the 3 guides and remove the lane departure warning camera as shown in the illustration.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.