Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection [09/2014 - 11/2017]: Procedure
2025 Toyota Sequoia CapstoneSECTION Procedure
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT CRUISE CONTROL MAIN SWITCH
- w/o Radar Cruise Control System:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Cruise Control Switch)- - Standard Resistance
Tester Connection Condition Specified Condition 1 (ECC) - 3 (CCS) Cruise control switch (ON-OFF button) released 1 MΩ or higher Cruise control switch (ON-OFF button) pushed Below 2.5 Ω +/RES 235 to 245 Ω -/SET 617 to 643 Ω CANCEL 1509 to 1571 Ω If the result is not as specified, replace the cruise control main switch.
- Measure the resistance according to the value(s) in the table below.
- w/ Radar Cruise Control System:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Cruise Control Switch)- - Standard Resistance
Tester Connection Condition Specified Condition 1 (ECC) - 2 (R/N) Cruise control switch (ON/OFF button) not pressed 1 MΩ or higher MODE Below 2.5 Ω 1 (ECC) - 3 (CCS) Cruise control switch (ON/OFF button) not pressed 1 MΩ or higher Cruise control switch (ON/OFF button) pressed Below 2.5 Ω +/RES 235 to 245 Ω -/SET 617 to 643 Ω CANCEL 1509 to 1571 Ω If the result is not as specified, replace the cruise control main switch.
- Measure the resistance according to the value(s) in the table below.
- w/o Radar Cruise Control System:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.