Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2025SEQUOIA CAPSTONEREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM - DIAGNOSTIC CODES (08 OF 12)
2025 Toyota Sequoia Capstone
Engine Control System - Diagnostic Codes (08 Of 12)
2025 Toyota Sequoia CapstoneSECTION Engine Control System - Diagnostic Codes (08 Of 12)
- SFI System
- DTC P0606-47: Control Module Processor Watchdog/Safety MCU Failure [09/2022 - ]
- DTC P0606-94: Control Module Processor Unexpected Operation [09/2022 - ]
- DTC P0607-47: Control Module Performance Bank 1 Watchdog/Safety MCU Failure; DTC P0607-87: Control Module Performance Bank 1 Missing Message [09/2022 - ]
- DTC P060D-49: Internal Control Module Accelerator Pedal Position Performance Internal Electronic Failure [09/2022 - ]
- DTC P060E-49: Internal Control Module Throttle Position Performance Internal Electronic Failure [09/2022 - ]
- DTC P0613-49: TCM Processor Internal Electronic Failure [09/2022 - ]
- DTC P0615-12: Starter Relay Circuit Short to Battery [09/2022 - ]
- DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [09/2022 - ]
- DTC P0630-51: VIN Not Programmed [09/2022 - ]
- DTC P0657-14: Actuator Supply Voltage "A" Circuit Short to Ground or Open [09/2022 - ]
- DTC P0657-9E: Actuator Supply Voltage "A" Stuck On [09/2022 - ]
- DTC P0703-12: Brake Switch "B" Circuit Short to Battery [09/2022 - ]
- DTC P0705-13: Transmission Range Sensor "A" Circuit Open; DTC P0705-62: Transmission Range Sensor "A" Signal Compare Failure [09/2022 - ]
- DTC P0715-31: Input/Turbine Speed Sensor "A" No Signal [09/2022 - ]
- DTC P075A-71: Shift Solenoid "G" Performance/Stuck Off Actuator Stuck [09/2022 - ]
- DTC P09A0-11: Shift Solenoid "G" Control Circuit Low Circuit Short to Ground [09/2022 - ]
- DTC P09A0-15: Shift Solenoid "G" Control Circuit High Circuit Short to Battery or Open [09/2022 - ]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.