Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Sensor Registration
2025 Toyota Prius XLE AWDSECTION Sensor Registration
NOTE:
When a tire pressure sensor and/or tire pressure monitor ECU are replaced, the sensor ID must be memorized (registered) by the tire pressure monitor ECU prior to system initialization. The ID codes can be registered in the SETTINGS DISPLAY (gear icon) of the multi-information display.
- Select SETTINGS DISPLAY (gear icon) on the multi-information display using the meter control switches on the steering wheel. See Figure.
- Select VEHICLE INFORMATION and then press and hold OK.
- Select TPWS and then press OK.
- Select CHANGE WHEEL then press and hold OK until the tire pressure warning light blinks slowly 3 times.NOTE: A message will then be displayed on the multi-information display. "---" will be displayed on the multi-information display for the inflation pressure of each tire while initialization is being performed.
- Drive straight (with occasional left and right turns) at approximately 25 mph (40 km/h) or more for approximately 10 to 30 minutes.
- Registration is complete when the tire pressure warning light turns off and the inflation pressure of each tire is displayed on the multiinformation display.NOTE: Initialization may take longer than approximately 1 hour in certain situations, such as when the vehicle is stopped for a long time at traffic lights, etc.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.