Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2025PRIUS XLE AWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSDIGITAL KEY SYSTEM - DIAGNOSTICS - INTRODUCTIONDIGITAL KEY SYSTEMREGISTRATION [12/2022 - ]PROCEDURE
2025 Toyota Prius XLE AWD
Registration [12/2022 - ]: Procedure
2025 Toyota Prius XLE AWDSECTION Procedure
- CLEAR ALL DIGITAL KEYS USING MULTI-DISPLAY NOTE:
- Make sure to use the electrical key when turning the ignition switch to ON (IG) and clearing all the digital keys.
- If all digital keys are cleared, both the owner key and share keys are cleared.
HINT:
In this document, an electrical key refers to a registered electrical key transmitter sub-assembly.
Procedure Steps 1. Start of erasure - Turn the ignition switch to ON using electrical key.
- Enter the following multi-display menu:
Settings / Info & Security / Delete the digital keys
2. Confirmation of registered electrical keys - In accordance with the display of the multi-display, touch the electrical key to the power switch.
- Confirm that the buzzer sounds once (short beep).
3. End of erasure - In accordance with the display of the multi-display, delete all digital keys.
- IMMOBILISER SYSTEM (KEY REGISTRATION)
HINT:
Refer to REGISTRATION [12/2022 - ]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.