SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2025HIGHLANDER XLE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSRESTRAINTS CONTROL SYSTEMSPRE-COLLISION SYSTEM - DIAGNOSTIC CODESPRE-COLLISION SYSTEMDTC U0418-81: INVALID DATA RECEIVED FROM BRAKE SYSTEM CONTROL MODULE INVALID SERIAL DATA RECEIVED [11/2023 - ]DESCRIPTION
2025 Toyota Highlander XLE, FWD

DTC U0418-81: Invalid Data Received from Brake System Control Module Invalid Serial Data Received [11/2023 - ]: Description

2025 Toyota Highlander XLE, FWDSECTION Description

for HV Model 

  1. The No. 2 skid control ECU (brake actuator assembly) sends signals indicating the status of the electronically controlled brake system to the forward recognition camera via CAN communication.

    If the forward recognition camera receives an electronically controlled brake system malfunction signal from the No. 2 skid control ECU (brake actuator assembly), it will store this DTC.

for Gasoline Model 

  1. The skid control ECU (brake actuator assembly) sends signals indicating the status of the electronically controlled brake system to the forward recognition camera via CAN communication.

    If the forward recognition camera receives an electronically controlled brake system malfunction signal from the skid control ECU (brake actuator assembly), it will store this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0418-81 Invalid Data Received from Brake System Control Module Invalid Serial Data Received for HV Model 
  1. When the ignition switch is ON for 3 seconds or more, the forward recognition camera receives an electronically controlled brake system malfunction signal from the No. 2 skid control ECU (brake actuator assembly) for 1 second or more.

for Gasoline Model 

  1. When the ignition switch is ON for 3 seconds or more, the forward recognition camera receives an electronically controlled brake system malfunction signal from the skid control ECU (brake actuator assembly) for 1 second or more.
  • Electronically controlled brake system
  • Forward recognition camera
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.