Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U0073: Control Module Communication Bus OFF; DTC U0126: Lost Communication with Steering Angle Sensor Module; DTC U0142: Lost Communication with Body Control Module "B"; DTC U0182: Lost Communication With Lighting Control Module Front [12/2019 - 11/2023]: Procedure
- CLEAR DTC
Result:
NEXT
See step 2
- CHECK FOR DTC
- Turn the ignition switch to ON.
- Wait 20 seconds or more.
- Check for DTCs.
Body Electrical > AFS (Sub) > Trouble Codes
OK
DTCs are not output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - ]
Result:
NG
GO TO CAN COMMUNICATION SYSTEM
for HV Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - 10/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2021 - 10/2022] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - 11/2023]
for Gasoline Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - 10/2022] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - 11/2023]
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.