Speedometer Cables

2025 Toyota Highlander PlatinumSECTION Speedometer Cables
Condition Code Procedure
Attaching hardware broken A Require repair or replacement of hardware
Attaching hardware missing C Require replacement of hardware
Attaching hardware not functioning A Require repair or replacement of hardware
Bent A Require repair or replacement
Binding A Require repair or replacement
Bracket bent, affecting performance A Require repair or replacement
Bracket bent, not affecting performance   No service suggested or required
Bracket broken, affecting performance A Require replacement
Bracket broken, not affecting performance   No service suggested or required
Bracket corroded, affecting performance A Require repair or replacement
Bracket corroded, not affecting performance 2 Suggest repair or replacement
Bracket cracked, affecting performance A Require repair or replacement
Bracket cracked, not affecting performance 1 Suggest repair or replacement
Bracket loose, affecting performance A Require repair or replacement
Bracket loose, not affecting performance 1 Suggest repair or replacement
Bracket missing C Require replacement
Broken A Require replacement
Cracked B Require repair or replacement
Disconnected A Require repair or replacement
Kinked A Require repair or replacement
Melted A Require repair or replacement
NOTE: Determine cause and correct prior to repair or replacement of part.
Missing C Require replacement
Noisy 2 Suggest repair or replacement
Routed incorrectly B Suggest repair
Seized A Require repair or replacement
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.