SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2025HIGHLANDER HYBRID XLEREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSRESTRAINTS CONTROL SYSTEMSPRE-COLLISION SYSTEM - DIAGNOSTIC CODESPRE-COLLISION SYSTEMDTC U0300-51: INTERNAL CONTROL MODULE SOFTWARE INCOMPATIBILITY NOT PROGRAMMED [09/2020 - 10/2022]DESCRIPTION
2025 Toyota Highlander Hybrid XLE

DTC U0300-51: Internal Control Module Software Incompatibility Not Programmed [09/2020 - 10/2022]: Description

2025 Toyota Highlander Hybrid XLESECTION Description

for HV Model 

  1. The forward recognition camera receives vehicle information from the hybrid vehicle control ECU via CAN communication.

    If the forward recognition camera cannot store the vehicle information, it will store this DTC.

for Gasoline Model 

  1. The forward recognition camera receives vehicle information from the ECM via CAN communication.

    If the forward recognition camera cannot store the vehicle information, it will store this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0300-51 Internal Control Module Software Incompatibility Not Programmed for HV Model 
  1. When the ignition switch is ON for 3 seconds or more, the vehicle information sent from the hybrid vehicle control ECU cannot be verified by the forward recognition camera for 3 seconds or more.

for Gasoline Model 

  1. When the ignition switch is ON for 3 seconds or more, the vehicle information sent from the ECM cannot be verified by the forward recognition camera for 3 seconds or more.
 for HV Model 
  • Hybrid control system
  • Forward recognition camera
  • Hybrid vehicle control ECU

for Gasoline Model 

  • SFI system
  • Forward recognition camera
  • ECM
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.