Quick Lookups: Fluids

2025 Toyota Corolla Cross L, FWDSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Automatic Transmission Fluid Gas 8.70 QTS. 8.23 L TOYOTA Genuine CVTF FE Using transmission fluid other than TOYOTA Genuine CVT Fluid FE may cause deterioration in shift quality, locking up of your transmission accompanied by vibration, and ultimately damage the transmission of your vehicle. S
Brake Fluid N/A N/A SAE J1703 or FMVSS No. 116 DOT 3 SAE J1704 or FMVSS No. 116 DOT 4 S
Engine Coolant Gas 6.70 QTS. 6.34 L TOYOTA Super Long Life Coolant or similar high-quality ethylene glycol-based non-silicate, non-amine, non-nitrate and non-borate coolant with long-life hybrid organic acid technology DO NOT use plain water alone. The fluid capacity is the quantity of reference. S
Engine Oil Gas Drain and Refill,w/Filter 4.40 QTS. 4.16 L TOYOTA Genuine Motor Oil. JASO GLV-1 SAE 0W-8 If SAE 0W-8 is not available, SAE 0W-16 oil may be used However, it must be replaced with SAE 0W-8 at the next oil change. S
Engine Oil Gas Drain and Refill,w/o Filter 4.10 QTS. 3.88 L TOYOTA Genuine Motor Oil. JASO GLV-1 SAE 0W-8 If SAE 0W-8 is not available, SAE 0W-16 oil may be used However, it must be replaced with SAE 0W-8 at the next oil change. S
Fuel Tank Gas,FWD 12.40 GALS. 46.93 L S
Transfer Case Fluid 0.47 QTS. 0.44 L TOYOTA Genuine Differential Gear Oil LT, SAE 75W-85 GL-5 or equivalent S
Windshield Washer Fluid N/A N/A Washer Fluid In cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.