Panoramic View Monitor System

2025 Toyota Camry LE, 2.5L Eng VIN ASECTION Panoramic View Monitor System
PANORAMIC VIEW MONITOR SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION

DTC Code Description
C1614-04 Circumference Monitoring Camera Control Module System Internal Failure
C161B-04 Rear Camera Control Module System Internal Failure
C1620-11 Rear Camera Circuit Short to Ground
C1622-87 Rear Camera Image Signal Missing Message
C1680-11 Front Camera Circuit Short to Ground
C1681-87 Front Camera Image Signal Missing Message
C168E-87 Side Camera (Left) Image Signal Missing Message
C168F-11 Side Camera (Left) Circuit Short to Ground
C169D-87 Side Camera (Right) Image Signal Missing Message
C169E-11 Side Camera (Right) Circuit Short to Ground
U0126-87 Lost Communication with Steering Angle Sensor Module Missing Message
U0129-87 Lost Communication with Brake System Control Module "A" Missing Message
U0131-87 Lost Communication with Power Steering Control Module Missing Message
U0140-87 Lost Communication with Body Control Module Missing Message
U0155-87 Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message
U0163-87 Lost Communication with Navigation Control Module Missing Message
U0198-87 Lost Communication with Telematic Control Module "A" Missing Message
U0293-87 Lost Communication with Hybrid/EV Powertrain Control Module Missing Message
U1110-87 Lost Communication with Clearance Sonar Module Missing Message
U114F-87 Lost Communication with Power Integration Module Missing Message
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.