Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2025CAMRY LE, 2.5L ENG VIN AREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - DIAGNOSTIC CODES (4 OF 7)
2025 Toyota Camry LE, 2.5L Eng VIN A
Engine Control System - Diagnostic Codes (4 Of 7)
2025 Toyota Camry LE, 2.5L Eng VIN ASECTION Engine Control System - Diagnostic Codes (4 Of 7)
- SFI System
- DTC P0420-00: Catalyst System Efficiency Below Threshold Bank 1 [04/2024 - ]
- DTC P043E-00: Evaporative Emission System Leak Detection Reference Orifice Low Flow; DTC P043F-00: Evaporative Emission System Leak Detection Reference Orifice High Flow; DTC P0446-72: EVAP System Vent Valve Stuck Open Actuator Stuck Open; DTC P2400-7E: Evaporative Emission System Leak Detection Pump Control Circuit Actuator Stuck On; DTC P2400-7F: Evaporative Emission System Leak Detection Pump Control Circuit Actuator Stuck Off [04/2024 - ]
- DTC P0441-7E: Evaporative Emission System Incorrect Purge Flow Actuator Stuck On; DTC P0441-7F: Evaporative Emission System Incorrect Purge Flow Actuator Stuck Off; DTC P0441-9C: Evaporative Emission System Incorrect Purge Flow Low/Insufficient Flow [04/2024 - ]
- DTC P0443-12: EVAP System Purge Control Valve "A" Circuit Circuit Short to Battery; DTC P0443-14: EVAP System Purge Control Valve "A" Circuit Circuit Short to Ground or Open [04/2024 - ]
- DTC P0450-11: Evaporative Emission System Pressure Sensor/Switch Circuit Short to Ground; DTC P0450-15: Evaporative Emission System Pressure Sensor/Switch Circuit Short to Battery or Open; DTC P0450-2F: Evaporative Emission System Pressure Sensor/Switch Signal Erratic [04/2024 - ]
- DTC P0466-73: EVAP System Vent Valve Stuck Closed Actuator Stuck Closed [04/2024 - ]
- DTC P0505-00: Idle Control System [04/2024 - ]
- DTC P050A-00: Cold Start Idle Control System Performance [04/2024 - ]
- DTC P050B-00: Cold Start Ignition Timing Performance [04/2024 - ]
- DTC P0520-12: Engine Oil Pressure Sensor/Switch "A" Circuit Short to Battery; DTC P0520-14: Engine Oil Pressure Sensor/Switch "A" Circuit Short to Ground or Open [04/2024 - ]
- DTC P0520-24: Engine Oil Pressure Sensor/Switch "A" Signal Stuck High; DTC P0520-2A: Engine Oil Pressure Sensor/Switch "A" Signal Stuck in Range [04/2024 - ]
- DTC P0524-77: Engine Oil Pressure Too Low (Severe); DTC P15F0-09: Engine Oil Pressure Too Low (Moderate); DTC P15F0-77: Engine Oil Pressure Too Low (Minor); DTC P15F1-09: Variable Oil Pump Component Failure; DTC P15F1-77: Variable Oil Pump Commanded Position Not Reachable [04/2024 - ]
- DTC P0560-14: System Voltage Circuit Short to Ground or Open [04/2024 - ]
- DTC P059A-71: Active Grille Air Shutter "A" Actuator Stuck; DTC P059A-79: Active Grille Air Shutter "A" Mechanical Linkage Failure [04/2024 - ]
- DTC P05A2-12: Active Grille Air Shutter "A" Circuit Short to Battery [04/2024 - ]
- DTC P0604-44: Internal Control Module Random Access Memory (RAM) Error Data Memory Failure [04/2024 - ]
- DTC P0606-47: Control Module Processor Watchdog/Safety MCU Failure [04/2024 - ]
- DTC P0607-47: Control Module Performance Bank 1 Watchdog/Safety MCU Failure; DTC P0607-87: Control Module Performance Bank 1 Missing Message [04/2024 - ]
- DTC P060E-49: Internal Control Module Throttle Position Performance Internal Electronic Failure [04/2024 - ]
- DTC P0627-12: Fuel Pump "A" Control Circuit Short to Battery [04/2024 - ]
- DTC P0627-14: Fuel Pump "A" Control Circuit Short to Ground or Open [04/2024 - ]
- DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [04/2024 - ]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.