Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2025CAMRY LE, 2.5L ENG VIN AREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM - SERVICE INFORMATIONTHROTTLE BODYREMOVAL [04/2024 - ]PROCEDURE
2025 Toyota Camry LE, 2.5L Eng VIN A
Removal [04/2024 - ]: Procedure
2025 Toyota Camry LE, 2.5L Eng VIN ASECTION Procedure
- DRAIN ENGINE COOLANT (for Engine)
Refer to PROCEDURE - Step 1
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 20 - REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 1
- REMOVE INLET AIR CLEANER ASSEMBLY
- DISCONNECT NO. 2 VENTILATION HOSE
- REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
- DISCONNECT NO. 5 WATER BY-PASS HOSE
- SEPARATE THROTTLE BODY WITH MOTOR ASSEMBLY
- DISCONNECT NO. 6 WATER BY-PASS HOSE NOTE:
If the throttle body with motor assembly has been struck or dropped, replace it.
- REMOVE THROTTLE BODY GASKET
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.