SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20254RUNNER SR5, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM - SERVICE INFORMATIONMANIFOLD ABSOLUTE PRESSURE SENSORREMOVAL [12/2024 - ]PROCEDURE
2025 Toyota 4Runner SR5, RWD

Removal [12/2024 - ]: Procedure

2025 Toyota 4Runner SR5, RWDSECTION Procedure
  1. REMOVE NO. 1 TURBO PRESSURE SENSOR 
    1. GTY1191261Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the No. 1 turbo pressure sensor connector.
      2. Using an 8 mm socket wrench, remove the bolt and No. 1 turbo pressure sensor from the intake manifold.
        NOTE:

        If the No. 1 turbo pressure sensor has been struck or dropped, replace it.

  2. REMOVE NO. 2 TURBO PRESSURE SENSOR 
    1. GTY1271754Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the No. 2 turbo pressure sensor connector.
      2. Slide the clip and disconnect the No. 3 air hose from the No. 2 turbo pressure sensor.
      3. Using an 8 mm socket wrench, remove the 2 bolts and No. 2 turbo pressure sensor from the intercooler assembly.
        NOTE:

        If the No. 2 turbo pressure sensor has been struck or dropped, replace it.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.